Brians 99 Silverado Stock floor body dropped over a set of 23's We've done full frame off blasted and on the rotissere. Tubular upper and lower control arms, Narrowed rearend, parallel 4-link with watts, 25 gallon aluminum fuel cell, Back half frame fully boxed. All frame pieces and tubing are TIG welded for looks and strength. Frame is painted Victory red to match the body. Theres a host of other modifications but you get the idea. Come check it out touring around the state at a show near you.

Here is a pic of the wheel sticking outside the fender. Keeping the truck from being able to drop anymore.

The wheel getting a little closer to where its going to sit. There won't be much left of the original inner fender by the time I'm done with it.

Passenger side firewall trimmed enough to get the wheel up in there. It needs to still be cut way out.

Driverside firewall cut. The booster is removed and I started relocating the wiring harness so that it will come out under the floor and the firewall will be cleaned up quite a bit

 


Just a comparison shot of the 23's next to the 20's he had. The wheels are huge!!!

Built a new rear clip out of 2x4 box tube. It slips into the stock frame 9 inches and will be gusted at each joint for strength.

Squared up and set level.


Rearend is narrowed 4 inches overall. I'll remove all of the old brackets and we'll blast the rearend.

The frame is fully boxed for strength.

Tank and exhaust mount.

Beginning of the rear bag mounts and tube work.

Finished product.

All the mounts are fully tig welded for strength and looks.

On the ground the panhard was temporary for the truck to make it to the n-tense bike and car show. It will be running a watts link.

New control arms we built in house. Featuring 1" uni balls, 1 1/4" 1/4 wall DOM. tubing. 3/4" narrow over stock, fully Tig welded for strength. These allow full articulation in the front without binding.

Current update on Brians Truck is that it now lay's body on 23's

The definition of stock floor body drop!

We completly removed the bulk head and bedsides for shortening the inner skin.

Fabbed up some new lower control arms, featuring 1" uniballs

Frame all blasted and on the rotissere.

All painted and assembled ready for the body.